To test that an IntelliTAG is working properly, you can verify that it detects openings and break-in attempts.
Activate the alarm in night mode to prevent the camera from triggering the alarm during your testing. After the alarm is activated, open the door normally. After a few seconds, you should hear the audible signal followed by a 110 dB siren. If this does not happen, recalibrate the IntelliTAG.
Repeat this operation, but this time, knock violently and repeatedly on your opening to simulate a break-in attempt. After a few seconds, you should hear the audible signal followed by a 110 dB siren. If this does not happen, increase the sensitivity of the IntelliTAG until it reaches a satisfactory sensitivity level.